Bed covering

Squeaks and rattles are my absolute nemesis, I'll do anything to avoid them and as such the boards had to come off again to be covered. I've used the same automotive carpet as for the interior panels, using the same method and materials as previous.

Here's the seat base covered and in position:


Followed by the seat back (shown here in 'bed' position):


It looks a bit like 'carpet-overload' at the moment, but once the bedding is in and the rest of the interior is fitted, none of this will be visible. It should also help to dampen noise a little too.
Here's the foam in position:


And finally, because Stone174 doesn't cut corners, a rear view of the seat back - also carpeted to give a better finish than leaving blank board:


Just the rear-most board left to do. After all this I'll need a lie-down!